How To Change The Battery In A Honda Pilot Key Fob. Insert the battery back into the motherboard with the positive sign facing out. Put the motherboard back into the key fob with the rubber film up against the buttons.
Line up the back of the key fob with the front, and press. Press down the lock button on the key fob after turning the key to the “on” position. Remember where the positive side and negative side goes.
When You Turn The Key Fob, You Will See A Small Latch At The Back.
Switch the ignition to the on position, then press and hold the “lock” button for one second. From there you can go out. Once the locks have cycled, your vehicle is in remote.
On The Top Side After You Have Removed The Key, You Will See A Small Opening Between The Two Halves Of The.
Insert the key and turn to the “on” position. Your key fob has a battery, which you can replace by pressing your thumb down right above the battery and prying it out with another hand. Turn the key to the “on” position and hold the “lock” button on the key fob for one second.
First, Open The Trunk And Locate The Battery Compartment.
Note the position of the positive and negative sides of the battery in the remote. Line the back of the key fob up with the front and press it. Twist the key to the “off” position after releasing the button.
Install The New Honda Key Battery Without Touching The Terminals.
Open your honda key fob. Remember where the positive side and negative side goes. How to change a dead coin cell battery in the combination key fob remote control and metal ignition key unit for the keyless entry system of a second generation 2009 to 2015 honda pilot suv with the replacement part number.
Turn The Key To The “On” Position And Hold The “Lock” Button On The Key Fob For One Second.
Onmost hondas, you will find it under a carpeted flap or inside an empty plasticbox. Press and hold the “lock” button for one second. Remove it with the jeweler’s screwdriver.